Can-Am X3 Aluminum Flat Dash and Console DIY Kit

It's finally here! This Can-Am X3 Aluminum Flat Dash kit has been long anticipated! This dash hits the big "ECC Three". We have designed it to be strong, light, and most importantly, simple. Designed to fit to the factory rear lower firewall, this is the perfect answer for the DIY race car builders. We have in-house ability to customize the placement of buttons, your cluster, radio, and more! The drive shaft tunnel has been designed with racers in mind, allowing you to easily quick change your drive shaft through the passenger front firewall. The Fuel Sending unit cap is super low profile, preventing any line-of-sight loss over the passenger side dash like we have seen in most other flat dash attempts.  

NOTES:

• All X3 chassis are slightly different, so you may need to trim/massage the ends and corners of our kit depending on the condition, year, and accessories in your car. 
• You will need a RIVNUT tool, Grinder, and drill bits in order to install this kit. Some parts may require additional attention to achieve a perfect fit. 
• The Can-Am cluster size and screw pattern has changed year to year. We have designed the pillar of this console to fit the large 2020 cluster style bezel. If you have any questions, please call before placing an order so we can work with you to adjust the design as needed. 
• This kit requires removing the center dash tube your brake reservoirs mount to, but we have designed, and will include, a relocation bracket for your electrical and reservoirs. 
• You will be grinding and drilling on your factory chassis, as well as (potentially) trimming plastics.